LED lamps and ground connection
●
The refrigerator LED lamps are specially designed for this refrigerator, do not replace
them by yourself. If you need replacement, please contact Panasonic Service Center.
●
If there is no grounding wiring plug in refrigerator, it should be connected with grounding
connection to prevent electrical hazard from electric leakage.
※
For safety, the ground connection should be done
(For refrigerators with plug (2-pin plug) and without a ground wire)
The ground connection will allow prevention of danger resulted from electricity leakage.
The ground connection can be performed in 2 ways as follows:
1. In case the power outlet (socket) already has a grounded outlet,
connect the ground wire to the screw used for ground
connection on the back of the refrigerator (for the screw used
for ground connection, please notice the symbol).
Then connect the other end to the ground outlet.
2. In case the power outlet (socket) does not have a grounded outlet,
connect the ground wire to the screw located on the back of the refrigerator (for the screw
used for ground connection, please notice the symbol).
Then connect the other end to the earth bar.
※
Prohibited spots for ground connection
●
Gas pipes and water supply pipes (dangers due to electric shock or explosion).
●
The ground wires of telephone cords and lightning rods (dangers due to lighting).
Moving or shifting
1
Remove ice trays, water and ice in the tank.
2
Unplug the appliance.
3
Adjust the adjustable legs (left and right) so that the legs do not
touch the floor.
4
Empty the water tray at the back of the refrigerator. Place
a container behind the tray at the back of the refrigerator, then
tilt the refrigerator backward to drain water from the tray.
This action requires 4 or more people, of which 2 people lift the
front of the refrigerator to prevent the refrigerator from sliding
and avoid the risk of accidents.
※
How to move and transport
●
At least 4 people are required to transport the refrigerator.
●
Each person lifts a corner of the refrigerator.
●
Do not transport by grabbing the refrigerator door.
Caution
●
When transporting, use straps to secure the refrigerator door
and avoid letting the door open by itself.
●
Do not place the refrigerator on its side when transporting,
as this may cause damage to the refrigerator.
●
After installation, wait at least 4 hours before plugging in the power to ensure that the
gas and oil in the compressor are in a stable state.
Ground wire
Dây nối đất
Drainage hole
10
Summary of Contents for PRIME+ NR-BW530X
Page 12: ...Parts identification 23 12 ...
