18
19
2
3
1
You can use the projector’s remote control to turn the power on and off for home theatre
system devices that have been recorded in the remote control.
Note:
B
At the time of purchase, a macro for turning the power on and off for PJ,
DVD, VCR and AMP all at once is set.
Note:
B
If the distance that the projector’s remote control has to operate is too far, or if
the remove control receiver of the home theatre system devices are obstructed,
this operation may not work correctly. Check the locations and directions of the
home theatre system devices to make sure that they can all be operated.
Turning the power for home theatre system devices on and off at once
Press and hold [SYSTEM] for 3 seconds or more.
The power for the registered devices will turn on.
6
4
5
(Example: When “USER1” is selected)
■
Setting the macro function
■
Using the macro function
(Example: When “USER3” is selected)
(Example: When “USER3” is selected)
Press [SYSTEM] once more.
To finish, press [SETUP], and then check operation.
✱
The length of time required for the macro function to finish operating effectively will vary
depending on the number of devices that have been recorded.
✱
The display will show the
devices that have been
recorded by the macro.
Press [SETUP] for 3 seconds or more.
Select “USER 1-3” and then press [ENTER].
Select “MACRO?” and then press [ENTER].
Select the device to be registered.
Press [SYSTEM].
When you have finished selecting
devices, press [ENTER].
✱
If a registered device is selected, the display will flash faster.
✱
If a registered device is selected, the display will flash faster.
✱
To register or delete another device, repeat steps 4 and 5.
✱
The macro function will be cleared and the display will flash more
slowly.
Clearing the macro function
