Chapter 3
Basic Operations — Switching on/off the projector
56 - ENGLISH
Making adjustments and selections
It is recommended that images are projected continuously for at least 30 minutes before the focus is adjusted.
6)
1) 8)
5)
3)
7) 9)
3)
2)
4)
1) 5) 7) 8) 9)
2)
6)
1) Press the <FOCUS> button to roughly adjust the focus of the image. (
x
page 58)
2) Change the setting of [PROJECTOR SETUP] menu
→
[PROJECTION METHOD] depending on the
installation mode. (
x
page 32)
f
Refer to “Navigating through the menu” (
x
page 65) for the operation of the menu screen.
3) Press the input selection (<RGB1/RGB2> or <RGB1/2>, <DIGITAL LINK>, <DVI-D>, <VIDEO>, <SDI>,
<HDMI>) button to select the input signal.
(SDI input is only for PT-DZ870E)
4) Adjust the front, back and sideway tilt of the projector with the adjustable feet. (
x
page 46)
5) Press the <SHIFT> button to adjust the position of the image.
6) If the input signal is an RGB signal, press the <AUTO SETUP> button.
7) Press the <ZOOM> button to adjust the size of the image to match the screen.
8) Press the <FOCUS> button again to adjust the focus.
9) Press the <ZOOM> button again to adjust the zoom and the size of the image to match the screen.
Note
f
When the projector is switched on for the first time after purchase as well as when [ALL USER DATA] in the [PROJECTOR SETUP] menu
→
[INITIALIZE] is executed, the focus adjustment screen is displayed after projection starts, then the initial setting screen is displayed. Refer to
“Start-up display” (
x
page 22) for details.
