Chapter 4
Settings — [DISPLAY OPTION] menu
ENGLISH - 105
Note
f
Press the <SHUTTER> button on the remote control or the control panel during fade-in or fade-out to cancel the fade operation.
Setting [STARTUP]
1) Press
as
to select [SHUTTER SETTING].
2) Press the <ENTER> button.
f
The
[SHUTTER SETTING]
screen is displayed.
3) Press
as
to select [STARTUP].
4) Press
qw
to switch the item.
[OPEN]
Projection begins with the shutter open when the power is turned on.
[CLOSE]
Projection begins with the shutter close when the power is turned on.
Setting [SHUT-OFF]
1) Press
as
to select [SHUTTER SETTING].
2) Press the <ENTER> button.
f
The
[SHUTTER SETTING]
screen is displayed.
3) Press
as
to select [SHUT-OFF].
4) Press
qw
to switch the item.
[KEEP CURRENT STATE]
When the projector is switched off, the projector turns into standby with the shutter status as is.
[OPEN]
When the projector is switched off, the projector turns into standby with the shutter left opened.
[CLOSE]
When the projector is switched off, the projector turns into standby with the shutter left closed.
[FREEZE]
Pause the projected image temporarily regardless of the playback of the external device.
1) Press
as
to select [FREEZE].
2) Press the <ENTER> button.
f
Press the <MENU> button to release.
Note
f
[FREEZE] is displayed on the screen when video is paused.
[WAVEFORM MONITOR]
Use the input signals from a connected external device to display in a waveform. Check whether video output (luminance) signal level is within
the recommended range for the projector and adjust.
1) Press
as
to select [WAVEFORM MONITOR].
2) Press
qw
to switch the item.
[OFF]
Does not display the waveform monitor.
[ON]
Displays the waveform monitor.
3) Press the <MENU> button two times to clear.
4) Press
as
to select any horizontal line.
5) Press the <ENTER> button to switch the Select line to either luminance, red, green, or blue.
f
Line selection items switch each time the <ENTER> is pressed only when the waveform monitor is displayed.
“Select line (luminance)”
Displayed in white waveform.
“Select line (red)”
Displayed in red waveform.
“Select line (green)”
Displayed in green waveform.
