Chapter 4
Settings — [PROJECTOR SETUP] menu
116 - ENGLISH
[STANDBY MODE]
Set the power consumption during the standby.
1) Press
as
to select [STANDBY MODE].
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[NORMAL]
Use this setting to use the network function during standby.
[ECO]
Use this setting to reduce power consumption during standby.
Note
f
In the [ECO] setting, the network function, the <SERIAL OUT> terminal, and some RS-232C commands become inoperable during standby.
In the [NORMAL] setting, the network function and the <SERIAL OUT> terminal become operable during standby.
f
When set to [ECO], it may take approx. 10 seconds longer before the projector starts projecting after the power is turned on, compared with
when [NORMAL] is set.
f
The [STANDBY MODE] setting is not reset to the factory default even when [ALL USER DATA] is executed from the [PROJECTOR SETUP]
menu
→
[INITIALIZE] (
x
page 123).
[SCHEDULE]
Set the command execution schedule for each day of the week.
Enabling/disabling the schedule function
1) Press
as
to select [SCHEDULE].
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[OFF]
Disables the schedule function.
[ON]
Enables the schedule function. Refer to “How to assign a program” (
x
page 116) or “How to set a
program” (
x
page 116) for how to set the schedule.
Note
f
When [SCHEDULE] is set to [ON], the [STANDBY MODE] setting is forcibly switched to [NORMAL], and the setting cannot be changed.
Even if [SCHEDULE] is then set to [OFF] when in this state, the setting of [STANDBY MODE] remains at [NORMAL].
How to assign a program
1) Press
as
to select [SCHEDULE].
2) Press
qw
to select [ON], and press the <ENTER> button.
f
The
[SCHEDULE]
screen is displayed.
3) Select and assign program to each day of week.
f
Press
as
to select the day of week, and press
qw
to select a program number.
f
You can set the program from No.1 to No.7. “- - -” indicates that the program number has not been set.
How to set a program
Set up to 16 commands to each program.
1) Press
as
to select [SCHEDULE].
2) Press
qw
to select [ON], and press the <ENTER> button.
f
The
[SCHEDULE]
screen is displayed.
3) Press
as
to select [PROGRAM EDIT].
4) Press
qw
to select a program number, and press the <ENTER> button.
5) Press
as
to select a command number, and press the <ENTER> button.
f
You can change the page using
qw
.
6) Press
asqw
to select [TIME], and press the <ENTER> button.
