Chapter 1
Preparation — Start-up display
ENGLISH - 23
Initial setting (installation setting)
Set [PROJECTION METHOD] and [COOLING CONDITION] depending on the installation mode. Refer to “Installation mode” (
x
page 32)
for details.
Set [HIGH ALTITUDE MODE] to [ON] when using the projector at high altitudes between 1 400 m (4 593') and 2 700 m (8 858') above sea
level.
After completed the initial setting, you can change the settings of each item from the [PROJECTOR SETUP] menu.
1) Press
as
to select an item.
2) Press
qw
to switch the setting.
2/4
When PROJECTION METHOD is changed, confirm that
COOLING CONDITION is set correctly.
It may shorten the life of the lamp and projector if used
in incorrect setting.
Switch to HIGH ALTITUDE MODE "ON" if over 1400m
(4593Ft).
INITIAL SETTING
SET
CHANGE
MENU SELECT
PROJECTION METHOD
COOLING CONDITION
FRONT/FLOOR
AUTO
HIGH ALTITUDE MODE
OFF
ENTER
3) Press the <ENTER> button to proceed to the initial setting.
Initial setting (stand by mode)
Set the operation mode during the standby. The default setting is [NORMAL], which allows you to use the network function during the standby.
To keep power consumption low during the standby, set this function to [ECO]. After completed the initial setting, you can change the setting
from the [PROJECTOR SETUP] menu
→
[STANDBY MODE].
1) Press
qw
to switch the setting.
3/4
When set to ECO, network functions and SERIAL OUT
terminal, and some RS-232C commands are not
available during standby.
INITIAL SETTING
SET
CHANGE
STANDBY MODE
NORMAL
ENTER
2) Press the <ENTER> button to proceed to the initial setting.
Note
f
The above initial setting screen is displayed when the projector is switched on for the first time after purchase. If [ALL USER DATA] is
executed from the [PROJECTOR SETUP] menu
→
[INITIALIZE], the [STANDBY MODE] item set before execution is displayed.
