Image adjust
58
- ENGLISH
Settings
Sharpness
Press ▲▼ to select [Sharpness].
1 )
Press the <ENTER> button
to display
2 )
the adjustment dialog box
.
Press ◄► to adjust the setting value.
3 )
Operation
Adjustment
Adjustment
range
Press ►.
increase the
sharpness of the
image
Maximum
value 31
Press ◄.
decrease the
sharpness of the
image
Minimum
value 0
Gamma
Press ▲▼ to select [Gamma].
1 )
Press the <ENTER> button to display
2 )
the adjustment dialog box
.
Press ◄► to adjust the gamma value
3 )
to obtain a better balance of contrast.
Adjustments can be made between
z
0 and 15.
Noise reduction
Press ▲▼ to select [Noise reduction].
1 )
Press the <ENTER> button to display
2 )
the adjustment dialog box
.
Press ◄► to select the desired item.
3 )
Off
Disabled
On
The function works
Noise interference on the screen can be
z
reduced. Select one of the above options to get
smoother images.
[Noise reduction] cannot be selected when
z
[1 080p] is selected.
Note
When input video signal to the projector, [Noise
z
reduction] will become available.
Progressive
Press ▲▼ to select [Progressive].
1 )
Press the <ENTER> button to display
2 )
the dialog box.
Press ◄► to select the desired item.
3 )
An interlaced video signal can be displayed in
z
progressive mode. Select one of the following
options.
[Progressive] cannot be selected when [480p],
z
[576p], [720p] or [1 080p] is selected.
Off
Disabled
On
The function works
Film
For watching a film
Note
When input video signal to the projector, [Progressive]
z
will become available.
Reset
To reset the adjusted data, all adjustments will return
to their previous figures.
Press ▲▼ to select [Reset].
1 )
Press the <ENTER> button.
2 )
A confirmation box appears and then select [Yes].
z
Note
To reset the adjusted data except [Daylight View].
z
Store
Press ▲▼ to select [Store].
1 )
Press ► or the <ENTER> button.
2 )
Press ▲▼ to select one from Image 1
3 )
to 10 and press the <ENTER> button.
A confirmation box appears and then select [Yes].
z
Note
To store the adjusted data except [Daylight View].
z
Make sure you selected [Store] after adjusting settings.
z
Some settings can not be stored if not registered with
[Store] function.
