Chapter 4
Settings — [SETUP] menu
ENGLISH - 71
Note
f
The content of status can be sent via E-mail to E-mail addresses (up to two) set in
“[E-mail set up] page” (
x
page 115) by pressing the
<ENTER> button while the [STATUS] screen is displayed.
[SCHEDULE]
Set the command execution schedule for each day of the week.
Enabling/disabling the schedule function
1) Press
as
to select [SCHEDULE].
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[OFF]
Disables the schedule function.
[ON]
Enables the schedule function. Refer to “How to assign a program” (
x
page 71) or “How to set a
program” (
x
page 71) for how to set the schedule.
Note
f
The [STANDBY MODE] setting will be fixed to [NORMAL] and cannot be changed when [SCHEDULE] is set to [ON]. The [STANDBY
MODE] setting will not change back when [SCHEDULE] is set to [OFF] in this condition.
f
When [SCHEDULE] is set to [ON], the schedule of the signage play will stop. The schedule of the signage play will not work even when
[SCHEDULE] is set to [OFF] in this condition.
How to assign a program
1) Press
as
to select [SCHEDULE].
2) Press
qw
to select [ON], and press the <ENTER> button.
f
The
[SCHEDULE]
screen is displayed.
3) Select and assign a program to each day of week.
f
Press
as
to select the day of week, and press
qw
to select a program number.
f
You can set the program from No.1 to No.7. “- - -” indicates that the program number has not been set.
How to set a program
Set up to 16 commands to each program.
1) Press
as
to select [SCHEDULE].
2) Press
qw
to select [ON], and press the <ENTER> button.
f
The
[SCHEDULE]
screen is displayed.
3) Press
as
to select [PROGRAM EDIT].
4) Press
qw
to select a program number, and press the <ENTER> button.
5) Press
as
to select a command number, and press the <ENTER> button.
f
You can turn the page using
qw
.
6) Press
as
to select [TIME], and press the <ENTER> button.
f
The projector is in the adjustment mode (the time is blinking).
7) Press
qw
to select "hour" or "minute", and press
as
to set a time, and then press the <ENTER>
button.
8) Press
as
to select [COMMAND].
9) Press the <ENTER> button.
f
The
[COMMAND]
detailed setting screen is displayed.
10) Press
as
to select a [COMMAND].
