Chapter 3
Basic Operations — Operating with the remote control
ENGLISH - 57
Using the AV mute function
The projection and the audio output can be paused temporarily when the projector is not used for specific time
such as during break or preparation.
button
1) Press the <AV MUTE> button.
f
The projection and the audio are stopped.
2) Press the <AV MUTE> button again.
f
The projection and the audio are resumed.
Note
f
The power indicator <ON (G)/STANDBY (R)> blinks in green in frequency of lighting 0.8 seconds → off 0.8 seconds while AV mute is in use.
f
The projector has no built-in speakers. Audio is output from the external sound system connected to the <AUDIO OUT> terminal.
Setting the remote control ID numbers
When you use the system with multiple projectors, you can operate all the projectors simultaneously or each
projector individually using single remote control, if a unique ID number is assigned to each projector.
After setting the ID number ([1] - [6]) of the projector, set same ID number on the remote control.
The factory default ID number of the projector is set to [ALL]. When using a single projector, press the <ID
ALL> button on the remote control. Also, you can control a projector by pressing the <ID ALL> button on
the remote control even if you do not know the projector ID.
button
1) Press the <ID SET> button on the remote control.
2) Within five seconds, press the number (<1> - <6>) buttons to set the one-digit ID number preset on
the projector.
f
If you press the <ID ALL> button, you can control the projectors regardless of the ID number setting of the
projector.
Attention
f
Since the ID number of the remote control can be set without the projector, do not press the <ID SET> button on the remote control
carelessly. If the <ID SET> button is pressed and no number (<1> - <6>) button is pressed within five seconds, the ID number returns to its
original value before the <ID SET> button was pressed.
f
The ID number set on the remote control will be stored unless it is set again. However, it will be erased if the remote control is left with dead
batteries. Set the same ID number again when the batteries are replaced.
Note
f
Set the ID number of the projector from the [SETUP] menu
→
[PROJECTOR ID].
