Projecting an image
Basic Operation
E
NGLISH - 25
Projecting an image
&RQ¿UPWKHFRQQHFWLRQVRIWKHSHULSKHUDOGHYLFHV
(
¨
page 19, 20) and mains lead (
¨
page 21). Switch on the
power (
¨
page 23) and the projector starts projecting. Select the input signal and adjust the image.
Selecting the input signal
1 ) Switch on the connected devices.
When playing a connected DVD player, if
SIGNAL
6($5&+
in the
DISPLAY OPTION
menu is set
to
ON
, the input signal is detected and projected
automatically when the projector is switched on.
(
¨
page 39)
Set the
z
INPUT GUIDE
under the
ON-SCREEN
DISPLAY
in the
DISPLAY OPTION
menu to
DETAILED
. If the projector cannot detect any
input signal, the Computer connection guidance
will display. (
¨
page 38)
2 ) Select an input signal.
The image selected with the
INPUT SELECT
button is projected. (
¨
page 26)
Note
Change the setting of the
z
PICTURE
menu
according to the connected device and DVD, video
tape, etc., to be played. (
¨
page 33)
&RQ¿UPWKHDVSHFWUDWLRRIWKHVFUHHQDQGLPDJH
z
Select the optimum aspect ratio. (
¨
page 35)
Positioning the image
:KHQVHWWLQJXSWKHSURMHFWRUIRUWKH¿UVWWLPHRUVHWWLQJXSDWDQHZSODFH\RXPXVWSHUIRUPWKHIROORZLQJRSHUDWLRQV
1 ) Adjust the vertical angle of the projector.
Place the projector at the right angle from the screen.
z
Press the adjuster buttons and adjust the vertical projection angle. Then, adjust the projected image to the
z
centre of the screen.
2 )
$GMXVWWKHSURMHFWLRQVL]HDQGIRFXV
Remove the Zoom-Focus ring cover
z
(
¨
page 14) and turn the zoom and focus rings to adjust the projected
image. After adjusting, be sure to install the Zoom-Focus ring cover to protect from dust.
Zoom ring
(ZOOM)
Focus ring
(FOCUS)
5HPDUNV
When you adjust the zoom after adjusting the focus, you may need to adjust the focus of the image again.
z
If keystone distortion occurs, see “KEYSTONE”.
z
(
¨
page 34)
