SECURITY menu
Settings
46 -
E
NGLISH
MENU LOCK
Press the
MENU
button to display the menu. You can
lock or unlock the menu operation.
Change setting
Change setting
2))
Unlock the menu operation
ON
Lock the menu operation
5HPDUNV
Once
z
MENU LOCK
is set to
ON
, you cannot use
the
MENU
button unless you input the correct
password.
The
z
MENU LOCK
is set to
2))
by default and
when initialised.
MENU LOCK PASSWORD
When
MENU LOCK
is set to
ON
, you can set a
MENU LOCK PASSWORD
.
3UHVVŸźŻŹEXWWRQVWRVHOHFWWKH
1 )
required character and press the
ENTER button.
(You can input up to 16 characters.)
To delete all the entered characters, move the
cursor to
ALL DELETE
and press the
ENTER
button. To delete a character, press the
'()$8/7
button or move the cursor to the required
character then press the
'()$8/7
button.
ALL DELETE
OK
CANCEL
MENU LOCK PASSWORD
SPACE
3UHVVŸźŻŹEXWWRQVWRVHOHFW2.DQG
2 )
press the ENTER button.
Select
CANCEL
or press the
MENU/RETURN
button to return to the previous menu without
setting.
5HPDUNV
:KHQXVLQJWKHSURMHFWRUIRUWKH¿UVWWLPHRUDIWHU
z
INITIALIZE ALL
operation is activated, the initial
password is set as
AAAA
.
Change your password regularly. Do not use a
z
simple password that is too easy to guess.
To reset the password to the initial password, see
z
“MENU LOCK PASSWORD” (
¨
page 56).
CONTROL DEVICE SETUP
You can enable/disable the button operations of the
control panel and remote control.
Change setting
Change setting
J
CONTROL PANEL
ENABLE
Enable the button operations
DISABLE
Disable the button operations
REMOTE CONTROLLER
J
ENABLE
Enable the button operations
DISABLE
Disable the button operations
5HPDUNV
If
z
DISABLE
LVVHWWKHFRQ¿UPDWLRQVFUHHQDSSHDUV
Select
OK
and press the
ENTER
button.
If any button is pressed when
z
DISABLE
is set, the
password screen appears.
Input the password which is set in the
SECURITY
menu.
The
z
PASSWORD
screen will be displayed for 10
seconds.
If you set both
z
CONTROL PANEL
and
REMOTE
CONTROLLER
to
DISABLE
, all the button
operations of the control panel and remote control
are disabled and you cannot turn off the power.
In the standby mode, press and hold the
z
ENTER
button of the control panel and
MENU
button for at
least 2 seconds. The buttons on the control panel
are enabled.
You can also enable the button operation by
pressing and holding the
ENTER
button of the
control panel and
MENU
button for at least 2
seconds while the projector is projecting.
