Projecting
30
- ENGLISH
Basic Operation
Check the connections of the peripheral devices and connection of the power cord (
Æ
page 27) and switch on the
power (
Æ
page 29) to start the projector. Select the image and adjust the state of the image.
Selecting the input signal
Select an input signal.
Press <INPUT> button on the control panel or the <INPUT>,
<COMPUTER>, <HDMI>, <VIDEO> button on the remote
control.
The image of the signal being input in the selected terminal is
z
projected.
Press <INPUT> button to display the [Source] menu. Press
z
▲▼ to select the desired input and press ► to enter.
How to adjust the state of the image
Adjust the projection angle.
1
)
Place the projector parallel to the screen, and then install it on a flat surface so that the screen becomes
z
rectangle.
If the image is tilted lower than the screen, extend the adjustable feet to make a rectangle screen.
z
For details, see “Adjusting the Projector's Height” (
z
Æ
page 24).
Adjust the zoom and the focus.
2
)
Turn the zoom lever and the focus ring to adjust the image.
Note
It is recommended that the images are projected continuously for at least 30 minutes before the focus is adjusted.
z
As the projection screen size changes if the focus ring is turned, turn the zoom lever to fine-tune the projection screen size
z
again.
If keystone distortion occurs, see [V Keystone] in the [Position] menu (
z
Æ
page 39).
Projecting
Focus Ring
Zoom Lever
