Chapter 4
Settings — [DISPLAY OPTION] menu
134 - ENGLISH
Note
f
The settings in [RESOLUTION] and [VERTICAL SCAN FREQUENCY] are displayed in [EDID STATUS].
f
The resolution and vertical scanning frequency settings may also be required on your computer or video device.
f
The computer, video device, or projector in use may require the power to be turned off and on again after configuring settings.
f
A signal may not be output with the resolution and vertical scanning frequency that have been set, depending on your computer or video
device.
Setting [DIGITAL LINK OUT] in [SLOT IN] (DIGITAL LINK input)
1) Press
as
to select [SLOT IN].
2) Press the <ENTER> button.
f
The
[SLOT IN]
screen is displayed.
3) Press
as
to select [DIGITAL LINK OUT].
4) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[ENABLE]
Select this item to output the DIGITAL LINK signal (including the audio signal) input to the <DIGITAL
LINK IN/LAN> terminal from the <DIGITAL LINK OUT> terminal.
[DISABLE]
Select this item not to output the DIGITAL LINK signal from the <DIGITAL LINK OUT> terminal.
Note
f
The DIGITAL LINK signal input to the <DIGITAL LINK IN/LAN> terminal is output from the <DIGITAL LINK OUT> terminal only when the
projector is in projection mode. It will not be output when the projector is in standby mode.
When the optional Wireless Presentation System Receiver Board (Model No.: TY-SB01WP) is
installed
Setting [SIGNAL LEVEL] in [SLOT IN] (PressIT input)
1) Press
as
to select [SLOT IN].
2) Press the <ENTER> button.
f
The
[SLOT IN]
screen is displayed.
3) Press
as
to select [SIGNAL LEVEL].
4) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[AUTO]
Automatically sets the signal level.
[64-940]
Fixes to [64-940].
[0-1023]
Fixes to [0-1023].
When the Function Board by other manufacturers is installed
Setting [SIGNAL LEVEL] in [SLOT IN] (SLOT input)
1) Press
as
to select [SLOT IN].
2) Press the <ENTER> button.
f
The
[SLOT IN]
screen is displayed.
3) Press
as
to select [SIGNAL LEVEL].
4) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[AUTO]
Automatically sets the signal level.
[64-940]
Fixes to [64-940].
[0-1023]
Fixes to [0-1023].
