Chapter 1
Preparation — About your projector
ENGLISH - 33
About your projector
Remote control
1
3
2
4
5
7
8
6
9
10
11
17
13
14
12
15
16
18
19
1
<STANDBY> button
Sets the projector to the state where the projector is turned
off (standby mode) when the <MAIN POWER> switch on the
projector is set to <ON> and in projection mode.
2
<POWER ON> button
Sets the projector to projection mode when the <MAIN
POWER> switch on the projector is set to <ON> and the power
is turned off (standby mode).
3 Remote control indicator
Blinks if any button in the remote control is pressed.
4
Lens buttons (<FOCUS>, <ZOOM>, <SHIFT>)
Adjusts the focus, zoom, and lens shift. (
x
page 79)
5 <MENU> button/<ENTER> button/
asqw
buttons
Used to navigate through the menu screen. (
x
page 88)
asqw
buttons are also used to enter the password in
[SECURITY] or enter characters.
6
<ON SCREEN> button
Switches the on-screen display function on (display) or off
(hide). (
x
page 84)
7
<INPUT MENU> button
Displays the input selection screen. (
x
page 78)
8
Input selection buttons (<DISPLAYPORT>, <SLOT>,
<HDMI1>, <HDMI2>)
Switches the input signal to project. (
x
page 77)
<SLOT> button can be used when the optional Function Board
equipped with corresponding input is installed in the slot on the
projector.
9
<FUNCTION> button
Assigns a frequently used operation as a shortcut button.
(
x
page 85)
When the <FUNCTION> button is held down, the
[FUNCTION
BUTTON]
screen is displayed. (
x
page 175)
10
Number (<0> - <9>) buttons
Used for entering an ID number or a password in a multiple
projector environment.
11
<ID ALL> button
Used to simultaneously control all the projectors with a single
remote control in a multi-projector environment. (
x
page 40)
12
<SHUTTER> button
Used to temporarily turn off the image. (
x
page 84)
13
<TEST PATTERN> button
Displays the test pattern. (
x
page 85)
14
<CEC> button
Displays the HDMI CEC operation screen. (
x
page 250)
15 <STATUS> button
Displays the projector information.
16
<DEFAULT> button
Resets the setting of the displayed sub-menu to the factory
default. (
x
page 89)
17
<ID SET> button
Sets the ID number of the remote control in a multiple projector
environment. (
x
page 40)
18 Remote control signal transmitter
19 Remote control wired terminal
This is a terminal used to connect to the projector via a cable
when the remote control is used as a wired remote control.
(
x
page 40)
Top
Bottom
Front
