Chapter 3
Basic Operations — Switching on/off the projector
76 - ENGLISH
Switching off the projector
1)
2)
1)
2)
4)
3)
1)
Press the <STANDBY> button.
f
The
[POWER OFF(STANDBY)]
confirmation screen is displayed.
2) Press
qw
to select [OK], and press the <ENTER> button.
(Or press the <STANDBY> button again.)
f
Projection of the image will stop, and the power indicator <ON (G)/STANDBY (R)> on the projector body
lights in orange. (The fan keeps running.)
3)
Wait for a few seconds until the power indicator <ON (G)/STANDBY (R)> of the projector body lights/
blinks red.
4)
Press the <OFF> side of the <MAIN POWER> switch to turn off the power.
Note
f
For approximately five seconds after the projector is turned off, the indicator does not light up even if the power is turned on.
f
Even when the <STANDBY> button is pressed and the projector is switched off, the projector consumes power if the main power
of the projector is on.
Usage of some functions is restricted but the power consumption during the standby mode is conserved when the [PROJECTOR SETUP]
menu
→
[STANDBY MODE] is set to [ECO].
f
While projecting, the power can be turned off by pressing the <OFF> side of the <MAIN POWER> switch, or by directly using the breaker
under conditions where the <MAIN POWER> switch of the projector cannot be switched off/on easily such as while installing on the ceiling.
However, the settings or adjustments performed right before the power is turned off may not be reflected.
