Chapter 3
Basic Operations — Operating with the remote control
86 - ENGLISH
Using the status function
Display the status of the projector.
button
1)
Press the <STATUS> button.
f
The
[STATUS]
screen is displayed.
10000h
10000h / 10000h
1/6
1.00
1h 23m
123456789012
27°C/80°F
31°C/87°F
31°C/87°F
31°C/87°F
31°C/87°F
MENU
EXIT
CHANGE
ENTER
E-MAIL/USB
SELF TEST
NO ERRORS
EXHAUST AIR TEMP.
OPTICS MODULE TEMP.
INTAKE AIR TEMP.
FIRMWARE VERSION
CONTINUOUS LIGHTING TIME
LIGHT RUNTIME
PROJECTOR RUNTIME
LIGHT1 TEMP.
LIGHT2 TEMP.
PROJECTOR TYPE
STATUS
PT-REQ12
SERIAL NUMBER
Note
f
The projector status can also be displayed using the menu operation. Refer to the [PROJECTOR SETUP] menu
→
[STATUS]
(
x
page 175) for details.
Setting ID number of the remote control
When you use the multiple projectors together, you can operate all the projectors simultaneously or each projector
individually using a single remote control, if a unique ID number is assigned to each projector.
After setting the ID number of the projector, set same ID number on the remote control.
The factory default ID number of the projector is set to [ALL]. When using a single projector, press the <ID
ALL> button on the remote control. Also, you can control a projector by pressing the <ID ALL> button on
the remote control even if you do not know the projector ID.
button
1)
Press the <ID SET> button on the remote control.
2)
Within five seconds, press and set the one‑digit or two‑digit ID number set on the projector body
using the number (<0> ‑ <9>) buttons.
f
If you press the <ID ALL> button, you can control the projectors regardless of the ID number setting of the
projector body.
Attention
f
Since the ID number of the remote control can be set without the projector body, do not press the <ID SET> button on the remote control
carelessly. If the <ID SET> button is pressed and no number (<0> - <9>) buttons are pressed within five seconds, the ID number returns to
its original value before the <ID SET> button was pressed.
f
The ID number set on the remote control will be stored unless it is set again. However, it will be erased if the remote control is left with dead
batteries. Set the same ID number again when the batteries are replaced.
Note
f
When the ID number of the remote control is set to [0], you can control the projector regardless of the ID number setting of the projector
body, as same as when [ALL] is set.
f
Set the ID number of the projector body from the [PROJECTOR SETUP] menu
→
[PROJECTOR ID].
