Chapter 2
Getting Started — Setting up
ENGLISH - 39
Setting up
Usable outlet
This projector supports AC 100 V to AC 120 V, and AC 200 V to AC 240 V as the power supply. A grounded outlet
supporting 30 A is required when using the projector with AC 200 V to AC 240 V. A grounded outlet supporting
15 A is required when using the projector with AC 100 V to AC 120 V.
The shape of the usable outlet differs depending on the power supply. Following illustrations are examples.
2P/3W 30 A 250 V
NEMA L6-30
2P/3W 30 A 250 V
Clock position 6h
2P/3W 15 A 125 V
Attention
f
Use the supplied power cord and ground at the outlet.
f
Use the power cord matching the used power supply voltage and outlet shape.
Note
f
The light output will decrease to approximately 1/3 when using the projector with AC 100 V to AC 120 V.
f
The supplied power cords vary depending on the country or region where you purchased the product.
Installation mode
The installation modes of the projector are as follows. Set [FRONT/REAR]/[FLOOR/CEILING] in the
[PROJECTOR SETUP] menu
→
[PROJECTION METHOD] (
x
page 148) depending on the installation mode.
Setting on a desk/floor and projecting forward
Setting on a desk/floor and projecting from rear
(Using the translucent screen)
Menu item
Setting value
Menu item
Setting value
[FRONT/REAR]
[FRONT]
[FRONT/REAR]
[REAR]
[FLOOR/CEILING]
[AUTO] or [FLOOR]
[FLOOR/CEILING]
[AUTO] or [FLOOR]
Mounting on the ceiling and projecting forward
Mounting on the ceiling and projecting from rear
(Using the translucent screen)
Menu item
Setting value
Menu item
Setting value
[FRONT/REAR]
[FRONT]
[FRONT/REAR]
[REAR]
[FLOOR/CEILING]
[AUTO] or [CEILING]
[FLOOR/CEILING]
[AUTO] or [CEILING]
