Chapter 4
Settings — [PROJECTOR SETUP] menu
ENGLISH - 139
Note
f
The power indicator <ON (G)/STANDBY (R)> will blink slowly in green while the no signal lights-out function is operating and the light source
is turned off.
f
When [NO SIGNAL LIGHTS-OUT] is set to anything other than [DISABLE], the following are the conditions to turn the light source back on
again from the condition that the light source has turned off by this function.
g
When the signal is input
g
When on-screen display such as menu screen (OSD) or input guide, a test pattern, or a warning message is displayed
g
When the power on <
b
> button is pressed
g
When the operation to disable the shutter function (shutter: open) is performed, such as pressing the <SHUTTER> button
g
When the operating environment temperature is around 0 °C (32 °F) and the light source is forced to turn on due to warm-up
[INITIAL STARTUP]
Set the startup method when the <MAIN POWER> switch is set to <ON>.
1) Press
as
to select [INITIAL STARTUP].
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[LAST MEMORY]
Starts up the projector in the condition before the <MAIN POWER> switch is set to <OFF>.
[STANDBY]
Starts up the projector in standby.
[ON]
Starts projecting immediately.
[STARTUP INPUT SELECT]
Set the input when the projector is switched on to start projection.
1) Press
as
to select [STARTUP INPUT SELECT].
2) Press the <ENTER> button.
f
The
[STARTUP INPUT SELECT]
screen is displayed.
3) Press
asqw
to select the input, and press the <ENTER> button.
[LAST USED]
Keeps the input selected last.
[RGB1]
Sets the input to RGB1.
[RGB2]
Sets the input to RGB2.
[DVI-D]
Sets the input to DVI-D.
[HDMI]
Sets the input to HDMI.
[DIGITAL LINK]
Sets the input to DIGITAL LINK.
[SDI1]
Sets the input to SDI1.
[SDI2]
Sets the input to SDI2.
[INPUT1] - [INPUT10]
*1
Sets the input to DIGITAL LINK, and switches the input of the Panasonic twisted-pair-cable
transmitter to the specified input.
*1
When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected to the projector, its input
name is automatically reflected from [INPUT1] to [INPUT10]. When an item that does not reflect the input name is selected, it will be disabled.
Note
f
If [BACKUP INPUT MODE] in the [DISPLAY OPTION] menu
→
[BACKUP INPUT SETTING] (
x
page 113) is set to [1], and the power is
turned off with the input set to HDMI in the previous use, the projection will start with DVI-D input even when [STARTUP INPUT SELECT] is
set to [LAST USED].
f
When [BACKUP INPUT MODE] is set to [2] using the [DISPLAY OPTION] menu
→
[BACKUP INPUT SETTING] (
x
page 113), and the
power is turned off with the input set to SDI2 in the pervious use, projection will start with the SDI1 input even if [STARTUP INPUT SELECT]
is set to [LAST USED].
[DATE AND TIME]
Set the time zone, date, and time of the built-in clock of the projector.
Setting the time zone
1) Press
as
to select [DATE AND TIME].
2) Press the <ENTER> button.
f
The
[DATE AND TIME]
screen is displayed.
