Chapter 3
Basic Operations — Switching on/off the projector
60 - ENGLISH
Initial setting (installation setting)
Set [PROJECTION METHOD] depending on the installation mode. Refer to “Installation mode” (
x
page 34) for
details.
After completed the initial setting, you can change the setting from the [PROJECTOR SETUP] menu
→
[PROJECTION METHOD].
1) Press
qw
to switch the setting.
3/7
ENTER
SET
CHANGE
Change the projection method if the screen display is
upside down or inverted.
PROJECTION METHOD
FRONT/FLOOR
INITIAL SETTING
2) Press the <ENTER> button to proceed to the initial setting.
Initial setting (standby mode)
Set the operation mode during standby mode. The factory default setting is [NORMAL], which allows you to use
the network function during standby mode. To keep power consumption low during standby mode, set this function
to [ECO]. After completed the initial setting, you can change the setting from the [PROJECTOR SETUP] menu
→
[STANDBY MODE].
1) Press
qw
to switch the setting.
4/7
When set to ECO, network functions and SERIAL OUT
terminal, and some RS-232C commands are not
available during standby.
INITIAL SETTING
SET
CHANGE
STANDBY MODE
NORMAL
ENTER
2) Press the <ENTER> button to proceed to the initial setting.
Note
f
The preceding initial setting screen is displayed when the projector is switched on for the first time after purchase. When [ALL USER DATA]
is executed from the [PROJECTOR SETUP] menu
→
[INITIALIZE], the [STANDBY MODE] setting before execution is displayed.
