Chapter 4
Settings — [PROJECTOR SETUP] menu
ENGLISH - 143
[PROJECTOR SETUP] menu
On the menu screen, select [PROJECTOR SETUP] from the main menu, and select an item from the sub-
menu.
Refer to “Navigating through the menu” (
x
page 86) for the operation of the menu screen.
[PROJECTOR ID]
The projector has an ID number setting function that can be used when multiple projectors are used side by side
to enable simultaneous control or individual control via a single remote control.
1) Press
as
to select [PROJECTOR ID].
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[ALL]
Select this item when controlling projectors without specifying an ID number.
[1] - [64]
Select this item when specifying an ID number to control individual projector.
Note
f
To specify an ID number for individual control, the ID number of a remote control must match the ID number of the projector.
f
When the ID number is set to [ALL], the projector will operate regardless of the ID number specified during remote control or computer
control.
If multiple projectors are set up side by side with IDs set to [ALL], they cannot be controlled separately from the projectors with other ID
numbers.
f
Refer to “Setting ID number of the remote control” (
x
page 84) for how to set the ID number on the remote control.
[PROJECTION METHOD]
Set the projection method in accordance with the installation status of the projector.
Change the [FRONT/REAR] setting when the screen display is inverted.
Change the [FLOOR/CEILING] setting when the screen display is upside down.
Setting [FRONT/REAR]
1) Press
as
to select [PROJECTION METHOD].
2) Press the <ENTER> button.
f
The
[PROJECTION METHOD]
screen is displayed.
3) Press
as
to select [FRONT/REAR].
4) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[FRONT]
Select this item when installing the projector in front of the screen.
[REAR]
Select this item when installing behind the screen (using translucent screen).
Setting [FLOOR/CEILING]
1) Press
as
to select [PROJECTION METHOD].
2) Press the <ENTER> button.
f
The
[PROJECTION METHOD]
screen is displayed.
3) Press
as
to select [FLOOR/CEILING].
4) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[AUTO]
Automatically detects the attitude of the projector by the built-in angle sensor.
Set [AUTO] normally.
[FLOOR]
Select this item when installing the projector on a desk, etc.
