Chapter 3
Basic Operations — Projecting
72 - ENGLISH
f
Set the [DISPLAY OPTION] menu
→
[RGB IN]
→
[RGB1 INPUT SETTING] in accordance with the signal input to the <RGB 1 IN> terminal.
Switching the input by displaying the input selection screen
The input of the image for projection can be selected by displaying the input selection screen.
1) Press the <INPUT MENU> button on the remote control.
f
The input selection screen is displayed.
INPUT SELECT
RGB1
RGB2
DVI-D
HDMI
DIGITAL LINK
SDI1
SDI2
SELECT
SET
ENTER
2) Press the <INPUT MENU> button again.
f
The input will switch each time you press the <INPUT MENU> button.
Note
f
Input can be switched by pressing
as
to select the input of the image for projection and pressing the <ENTER> button while the input
selection screen is displayed.
f
The
[P IN P MODE]
screen is displayed when the <INPUT MENU> button is pressed while in the P IN P. (
x
page 176)
f
If the optional DIGITAL LINK output supported device (Model No.: ET‑YFB100G, ET‑YFB200G) is connected to the projector, the input
selection menu for the DIGITAL LINK output supported device is displayed when the <ENTER> button is pressed while the DIGITAL LINK
input is selected in the input selection screen.
f
If the optional DIGITAL LINK output supported device (Model No.: ET‑YFB100G, ET‑YFB200G) is connected to the projector, the DIGITAL
LINK logo and the input name selected in the DIGITAL LINK output supported device are displayed in the display section of the [DIGITAL
LINK] in the input selection screen.
f
Set the [DISPLAY OPTION] menu
→
[RGB IN]
→
[RGB1 INPUT SETTING] in accordance with the signal input to the <RGB 1 IN> terminal.
Adjusting the focus, zoom, and lens shift
Adjust the focus, zoom, and lens shift if the image projected to the screen or its position is shifted even if the
projector and the screen are set up in the correct positions.
This section describes the adjustment method when anything other than the Fixed‑focus Lens (Model No.:
ET‑D75LE95, ET‑D75LE90) is used. When the Fixed‑focus Lens (Model No.: ET‑D75LE95, ET‑D75LE90) is
used, refer to “Adjusting the focus when the Fixed‑focus Lens (Model No.: ET‑D75LE95, ET‑D75LE90) is used”
(
x
page 73).
Using the control panel
1) Press the <LENS> button on the control panel.
f
Pressing the button changes the adjustment screen in the order of [FOCUS], [ZOOM], and [SHIFT].
2) Select each item and press
asqw
to adjust it.
Using the remote control
1) Press the lens buttons (<FOCUS>, <ZOOM>, <SHIFT>) on the remote control.
f
Pressing the <FOCUS> button: Adjusts the focus (adjustment of the lens focus position).
f
Pressing the <ZOOM> button: Adjusts the zoom (adjustment of the lens zoom position).
f
Pressing the <SHIFT> button: Adjusts the lens shift (vertical position and horizontal position of the lens).
2) Select each item and press
asqw
to adjust it.
