Chapter 3
Basic Operations — Projecting
52 - ENGLISH
Using the remote control
1)
Press the lens buttons (<FOCUS>, <SHIFT>) on the remote control.
f
<FOCUS> button: Adjusts focus.
f
<SHIFT> button: Adjusts shift.
2) Select each adjustment item and press
asqw
to adjust.
CAUTION
Do not insert the hand into the opening around the lens while performing the lens shift operation.
Your hand may be caught in between, resulting in injury.
Note
f
The adjustment can be performed faster by holding down
asqw
for approximately three seconds or longer while adjusting the focus.
f
The adjustment can be performed faster by holding down
asqw
for approximately six seconds or longer while adjusting the shift.
f
It is recommended that images be projected continuously for at least 30 minutes before the focus is adjusted.
Only [FOCUS] is displayed in yellow so that the displayed menu item can be recognized by color, even when the displayed characters are
unreadable due to incorrect focus. (Factory default)
f
The displayed color of [FOCUS] differs depending on the setting of the [DISPLAY OPTION] menu
→
[ON-SCREEN DISPLAY]
→
[OSD
DESIGN].
f
The projector will not operate by pressing the <ZOOM> button.
f
When the projector is switched off during the shift adjustment, lens calibration needs to be performed the next time the projector is switched
on. (
x
page 115)
f
When the main power is switched off during the shift adjustment, the lens calibration error screen is displayed during the next shift
adjustment. Execute the [PROJECTOR SETUP] menu
→
[LENS CALIBRATION].
f
When the lens calibration error is displayed even though [LENS CALIBRATION] was executed, ask your dealer to repair the unit.
Moving the lens position to the home position
To move the lens position to the home position, perform the following procedure.
1) Press the <DEFAULT> button on the remote control while the shift adjustment screen is displayed.
f
The
[HOME POSITION]
screen is displayed.
LENS
HOME POSITION
EXECUTE
CANCEL
ENTER
MENU
2) Press the <ENTER> button.
f
[PROGRESS] is displayed in the
[HOME POSITION]
screen, and the lens position returns to the home
position.
Note
f
Complete the operation within approximately 5 seconds after the
[HOME POSITION]
screen is displayed. The
[HOME POSITION]
screen
will disappear after time limit.
f
The home position of the lens is used when the projector is being stored, and it is not the optical center of the screen.
f
You can also display the
[HOME POSITION]
screen by pressing the <LENS> button on the control panel or the <SHIFT> button on the
remote control for at least three seconds.
