Chapter 4
Settings — [PICTURE] menu
ENGLISH - 69
Operation
Adjustment
Range of adjustment
Press
w
.
Brightness of the white part gets stronger.
0 - +10
Press
q
.
The image becomes more natural.
[GAMMA]
You can switch gamma mode.
1) Press
as
to select [GAMMA].
2) Press
qw
or the <ENTER> button.
f
The
[GAMMA]
individual adjustment screen is displayed.
3) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[DEFAULT]
Factory default setting.
[1.8]
Set so that images become as you like.
[2.0]
[2.2]
Note
f
In the following conditions, the [DEFAULT] setting is disabled even when it is selected, and the same gamma mode as when [2.2] is set is
applied.
g
When the [ADVANCED MENU] menu
→
[EDGE BLENDING] is set to anything other than [OFF]
g
When the levels of [WHITE], [RED], [GREEN], and [BLUE] are adjusted from the [DISPLAY OPTION] menu
→
[UNIFORMITY]
g
When the [DISPLAY OPTION] menu
→
[UNIFORMITY]
→
[PC CORRECTION] is set to [ON]
[DAYLIGHT VIEW]
You can correct the image to the optimal vividness even if it is projected under a bright light.
1) Press
as
to select [DAYLIGHT VIEW].
2) Press
qw
or the <ENTER> button.
f
The
[DAYLIGHT VIEW]
individual adjustment screen is displayed.
3) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[AUTO]
Detects the brightness of the installed environment by the luminance sensor, and automatically
corrects the vividness of the image.
[OFF]
No correction.
[1]
Corrects the image to weaken vividness.
[2]
Corrects the image to medium vividness.
[3]
Corrects the image to high vividness.
Note
f
[AUTO] cannot be selected when the [ADVANCED MENU] menu
→
[EDGE BLENDING] is set to [ON] or [USER].
f
[AUTO] cannot be selected when the [PROJECTOR SETUP] menu
→
[FRONT/REAR] of [PROJECTION METHOD] is set to [REAR].
f
The luminance may not be detected correctly when an object is placed on top of the projector, blocking the luminance sensor. In such a
case, this function may not operate properly even if it is set to [AUTO].
f
The factory default setting is [OFF] when the [PICTURE] menu
→
[PICTURE MODE] is set to [NATURAL], [REC709], or [DICOM SIM.]. In
this case, [AUTO] cannot be selected.
[SHARPNESS]
You can adjust the sharpness of the projected image.
1) Press
as
to select [SHARPNESS].
2) Press
qw
or the <ENTER> button.
f
The
[SHARPNESS]
individual adjustment screen is displayed.
3) Press
qw
to adjust the level.
