Chapter 2
Getting Started — Connecting
ENGLISH - 53
For <SDI IN> terminal
(Only for PT-RZ770, PT-RZ660)
SD-SDI signal, HD-SDI signal, or 3G-SDI
signal
Digital VCR for commercial use
Note
f
The input format can be switched using the [PICTURE] menu
→
[SYSTEM SELECTOR].
f
Setting of the [DISPLAY OPTION] menu
→
[SDI IN] may be necessary depending on the connected external device.
f
Use a connection cable 5CFB or higher (such as 5CFB or 7CFB), or Belden 1694A or higher to properly transmit the image. Use a
connection cable with length of 100 m (328'1") or shorter.
f
An error in signal detection may occur when unstable signal is connected. In such a case, use the [PICTURE] menu
→
[SYSTEM
SELECTOR] to switch to a system that matches the signal format.
Connecting example: Computers
Control computer
Computer
Computer
Computer
Computer
Control computer
Attention
f
When connecting the projector to a computer or an external device, use the power cord supplied with each device and commercially
available shielded cables.
Note
f
Switching of the setting in the [DISPLAY OPTION] menu
→
[DVI-D IN]
→
[EDID SELECT] may be required depending on the connected
external device when DVI-D is input.
f
For the HDMI cable, use an HDMI High Speed cable that conforms to the HDMI standards. If a cable that does not conform to the HDMI
standards is used, images may be interrupted or may not be projected.
f
The <HDMI IN> terminal of the projector can be connected to an external device equipped with a DVI-D terminal using an HDMI/DVI
conversion cable. However, this may not function properly for some external devices, and image may not be projected.
f
The <DVI-D IN> terminal supports single links only.
f
When entering the SYNC ON GREEN signal, do not enter sync signals to the <SYNC/HD> terminal or the <VD> terminal.
f
If you operate the projector using the computer with the resume feature (last memory), you may have to reset the resume feature to operate
the projector.
