AUTO PC adjust
ENGLISH -
39
Settings
AUTO PC adjust
Select [PC adjust] from the Main Menu (see
“Navigating through the menu” on page 34),
then select the item from the sub-menu.
Remote control
Control panel
Auto PC adj.
Auto PC adjustment function is provided to
automatically adjust Fine sync, Total dots, Horizontal
and Vertical positions to conform to your computer.
Press ▲▼ to select [Auto PC adj.] and
then press the <ENTER> button.
[Please wait...]
z
appears while the Auto PC
adjustment is in process.
To store adjustment parameters
The adjusted parameters from the Auto PC adjustment
can be stored in the projector. Once the parameters
are stored, the setting can be done just by selecting a
Mode (1–10) in the PC System Menu (see page 37).
See also [Store] on page 41.
Attention
[Fine sync], [Total dots], [Horizontal] and [Vertical]
z
position of some computers cannot be fully adjusted
with the Auto PC adjustment function. When the
image is not provided properly with this operation,
manual adjustments are required (
Æ
pages 40-41).
The Auto PC adjustment cannot be operated when
z
[480i], [576i], [480p], [576p], [720p], [1035i] or [1080i]
is selected in the PC System Menu (
Æ
page 37), or
when the signal is coming from the HDMI terminal.
