Setting
ENGLISH -
53
Settings
Direct on
Press ▲▼ to select [Direct on] and
1 )
then press the <ENTER> button.
Press ▲▼ to switch between On and
2 )
Off.
When this function is set to [On], the projector
z
will be automatically turned on just by
connecting the AC power cord to a wall outlet.
Be sure to turn off the projector properly. If the
z
projector is turned off in the incorrect sequence,
the [Direct on] function does not work properly.
Standby mode
This function can set the electric power when the
projector is standing by.
Press ▲▼ to select [Standby mode]
1 )
and then press the <ENTER> button.
Press ▲▼ to switch between the items
2 )
as below.
Eco
Restricts some functions in
standby mode to reduce power
consumption.
Network
Does not restrict functionality
even in standby mode.
Note
When selecting [Network], the cooling fans may be
z
running depending on the temperature inside the
projector even if the projector is turned off.
Refer to "Operating Instructions - Network Operations
z
".
If Standby mode is set to [Eco], you cannot use network
z
functions when the projector is standing by. Also, you
cannot use some RS-232C protocol commands.
If set to [Network], you can use network functions when
z
the projector is standing by.
P-timer
This function allows you to change the setting of the
P-timer and execute it.
Press ▲▼ to select [P-timer].
1 )
Press ► or <ENTER> button to access
2 )
the submenu.
Mode
J
Press ▲▼ button to select one mode
1 )
among the items as below.
Count up
The P-timer display 000:00
appears on the screen and the
count up starts (000:00-180:00).
Count down
The time set in the Timer setting
appears on the screen and the
countdown starts.
Timer
J
Press ▲▼ to select [Timer] and then
1 )
press the <ENTER> button.
Press▲▼ to set the [Timer](1-180 Min).
2 )
Timer is available in [Count down] only. Factory
z
default value is 10 Min.
Execute
J
Press ▲▼ to select one among the
1 )
items as below and then press the
<ENTER> button.
Start
It executes the count up or count
down function.*
1
Reset
Reset the P-timer values.*
2
Exit
To exit the P-timer operation.
Press the <ENTER> button at Start and the
*1 :
indication changes into Stop. To stop Count up or
Count down, press the <ENTER> button at Stop
on the screen menu, then the indication changes
into Restart. Press the <ENTER> button at
Restart to resume Count up or Count down.
Press the <ENTER> button at Reset to return to
*2 :
the following value:
Count up
"000:00"
Count down
Timer that you set.
Attention
To stop the [P-timer] function, press the <P-TIMER>
z
button.
To cancel the [P-timer], press and hold the <P-TIMER>
z
button for a few seconds.
