Move the image position vertically or horizontally if the image position projected on the screen is shifted even
when the relative position of the projector and the screen is installed correctly.
1) Press
as
to select [SHIFT].
2) Press the <ENTER> button.
f
The
[SHIFT]
screen is displayed.
3) Press
asqw
to adjust the position.
Orientation
Operation
Adjustment
Vertical (up and down)
adjustment.
Press the
a
button.
The image position moves up.
Press the
s
button.
The image position moves down.
Horizontal (right and left)
adjustment.
Press the
w
button.
The image position moves to the right.
Press the
q
button.
The image position moves to the left.
Note
f
Depending on the input signal, if the adjustment of [SHIFT] exceeds the effective adjustment range of the input signal, the position of the
image cannot be changed. Adjust within the effective adjustment range.
[DOT CLOCK]
(Only for COMPUTER1 input / COMPUTER2 input)
Adjust to reduce noise generated when projecting vertical stripes.
When projecting a striped pattern, periodic stripes (noise) may occur. In this case, adjust so that the noise is the
least.
1) Press
as
to select [DOT CLOCK].
2) Press
qw
or the <ENTER> button.
f
The
[DOT CLOCK]
individual adjustment screen is displayed.
3) Press
qw
to adjust.
f
The adjustment values are [-32] to [+32].
Attention
f
Set it before adjusting [CLOCK PHASE].
[CLOCK PHASE]
(Only for COMPUTER1 input / COMPUTER2 input)
You can adjust to achieve an optimal image when there is a flickering image or smeared outlines.
1) Press
as
to select [CLOCK PHASE].
2) Press
qw
or the <ENTER> button.
f
The
[CLOCK PHASE]
individual adjustment screen is displayed.
3) Press
qw
to adjust the value.
78 -
ENGLISH
Chapter 4 Settings - [POSITION] menu
