2) Press the <ENTER> button to proceed to the initial setting.
Initial setting (installation setting)
Set each item.
PT-VW355N
PT-VX425N
1) Press
as
to select an item.
Item
Description
Page
[PROJECTION METHOD]
Set [PROJECTION METHOD] depending on the installation mode.
After completed the initial setting, you can change the setting from the
[PROJECTOR SETUP] menu → [PROJECTION METHOD].
78
[SCREEN FORMAT]*
1
Set the screen format (aspect ratio) and display position of the image.
After completed the initial setting, you can change the settings of each
item from the [DISPLAY OPTION] menu → [SCREEN SETTING].
72
[SCREEN POSITION]*
1
Set the display position of the image.
After completed the initial setting, you can change the settings of each
item from the [DISPLAY OPTION] menu → [SCREEN SETTING].
72
[HIGH ALTITUDE MODE]
Change the setting when the projector is used at high altitude.
Set it to [OFF] when using the projector at altitude lower than 1 400 m
(4 593'), set it to [HIGH1] when using the projector at altitude between
1 400 m (4 593') and 2 000 m (6 562') above sea level, and set it to
[HIGH2] when using the projector at altitude between 2 000 m (6 562')
and 2 700 m (8 858') above sea level.
78
*1 Only for PT-VW355N.
2) Press
qw
to switch the setting.
3) Press the <ENTER> button to perform next initial setting.
ENGLISH
-
43
Chapter 3 Basic Operations - Powering on/off
