11. To move the cursor press MUTE on the remote (cursor flashes), then
move the cursor to any of the positions for “EASY” mode
12. This adjustment may help to make rounded lines become straight
lines.
13. Adjust to make lines as straight as possible
14. Enter to POINT “G-POINT” (for green) mode by pressing TV/VIDEO.
15. “POINT” mode allows to move line horizontally and vertically from
the perimeter of cursor making rounded lines become straight
16. In “POINT” mode, the adjustment data changes by 2 steps, See
values on screen by pressing RECALL on remote
17. When the cursor is located in the outer area of the border the cursor
starts to flash from one side to other, the location is for the non-visible
area and the most outer side of screen (inside the ovals area, see
figure); This applies to “LINE”, “POINT” & “ORIGIN.POINT” modes.
18. Begin adjustment from the center to the edge of the screen
“POINT” & “ORIG. POINT” mode adjustment
19. Adjust to make lines as much straight as possible
67
Summary of Contents for PT47WX34J - 47" PROJECTION TV
