I
NSTALLATION
5
z
ENGLISH
Installation
Television Location
This unit can be used as part of an entertainment center.
Consult your dealer for available options.
•
Avoid excessive sunlight or bright lights, including
reflections.
•
Keep away from excessive heat or moisture. Inadequate
ventilation may cause internal component failure.
•
Fluorescent lighting may reduce remote control
transmitting range.
•
Keep away from magnetic equipment, including motors,
fans and external speakers.
Component Connection Cables
Shielded audio and video cables should be used between
components. For best results:
•
Use 75-ohm coaxial shielded cables.
•
Use appropriate input and output connectors, that match
your component connectors.
•
Avoid long cables to minimize interference.
AC Power Supply Cord
CAUTION:
TO PREVENT ELECTRIC SHOCK,
MATCH WIDE BLADE OF PLUG TO WIDE SLOT
OF AC OUTLET AND FULLY INSERT. DO NOT
USE A PLUG WITH A RECEPTACLE OR OTHER
OUTLET UNLESS THE BLADE CAN BE FULLY INSERTED TO
PREVENT BLADE EXPOSURE.
PROTECT POWER CORDS FROM BEING WALKED ON, ROLLED
OVER, CRIMPED, BENT, OR PINCHED, PARTICULARLY AT PLUGS,
CONVENIENCE RECEPTACLES, AND THE POINT WHERE THEY EXIT
FROM THE APPARATUS.
Cable / Antenna Connection
For proper reception of analog or digital cable channels, a
cable service connection is required.
Cable Connection
Connect the cable supplied by your local
cable company to ANTENNA (A)
connection on back of television. Select
Cable mode and ANTENNA (A) in SET UP
menu under Program CH (Program
Channels).
Antenna Connection
•
For proper reception of digital and analog VHF/
UHF channels, an external antenna is required. For
best reception an outdoor antenna is
recommended.
•
Connect home antenna to
either ANT (A) or ANT (B)
connection on
back of the
television. Select Antenna
mode for ANTENNA (A) or
(B) in Input Setup under
Program CH in Setup menu.
Note:
Cable Mode is preset at the factory. Antenna users must
change to ANTENNA Mode for ANTENNA (A) in the Set
Up menu. If you have both Cable and Antenna, the
Cable
must
be connected to ANT (A).
External Shelf (mounted on top)
(models PT-47XD64 and PT-53XD64 only)
For your convenience, optional devices such as a Satellite
Receiver, a Cable Box, a DVD player, a VCR or a center channel
speaker can be placed on this shelf.
CAUTION: The weight limit of this shelf must not
exceed 25 lbs.
Remote Control Battery Installation
Use two AA batteries (supplied):
1. Remove battery cover by pushing in on the catch while
lifting the cover up.
2. Install batteries by matching (+) and (-) polarity signs in
the compartment.
3. Re-insert the cover and press down the cover until it
snaps shut.
Note:
Incorrect installation can cause battery leakage and
corrosion that will damage the Remote Control.
Precautions
•
Replace batteries in pairs.
•
Do not mix battery types (example: zinc carbon with
alkaline).
•
Do not recharge, heat, short circuit, disassemble, or burn
batteries.
•
Battery replacement is necessary when the remote
control acts sporadically or stops operating the selected
device.
Polarized plug
75 Ohm ANT A
Incoming Cable from
Cable Company
Incoming Cable from
Home Antenna
+
-
+
-
+
+
-
+
-
1
2
3
Summary of Contents for PT53TWD64 - 53" PROJECTION TV
Page 39: ...NOTES 37 z ENGLISH ...
Page 77: ...NOTAS 37 z ESPAÑOL ...
