7. Unscrew the 2 screws and while pressing to shut each hook of the 2 resinous stands, remove the B-P.C.Board.
2. 9. Removal of K1-P.C.board / K2-P.C.Board
1. Remove the A-P.C.Board earth metal according to the steps 1 through 5 in the section
2.4. "Removal of Optical Block / Analysis Block".
2. Unscrew the 4 screws and remove the Optical Block and Analysis Block.
3. Unscrew the 3 screws and remove the Lamp house.
4. Unscrew the 2 screws and remove the Lamp duct base.
Optical Block + Analysis Block
Lamp house
Lamp duct base
Note :
1) The direction the Power Fan install.
2) Roll the Fan cable one turn on core.
B-P.C.Board
B-P.C.B
Resinous stands
XTBT969FJK
XTV3+10GFJ
XTBT969FJK
XTBT969FJK
DIS-9
Summary of Contents for PT_AT6000E
