15
Before Use
• When the button-type battery is exhausted, replace
it with a new CR2025 battery. (A battery is normally
expected to last about 1 year. However, it depends
on operation frequency.)
• Make sure to match the poles correctly when
inserting the button-type battery.
WARNING
CAUTION
●
Replace Battery with Panasonic or Lixing
type CR2025 only. Use of another battery
may present a risk of
fi
re or explosion.
●
Battery may explode if mistreated.
●
As with any small object, this type of Battery
can be swallowed by young children. Do not
allow children to handle this Battery.
●
Dispose of used battery promptly.
●
Do not recharge, disassemble or dispose of
in
fi
re.
Using the Remote Control
(PV-GS15 Only)
• Distance from the Camcorder: Within
approximately 15 feet (5 meters)
• Angle: Within approximately 15° in the vertical and
horizontal directions from the central axis
1 Direct the Remote Control at the Remote
Control Sensor
31
of the Camcorder and
press an appropriate button.
[VCR1]:
Press the [ ] Button and [ ] Button
simultaneously.
1
[VCR2]:
Press the [ ] Button and [ ] Button
simultaneously.
2
• When the battery in the Remote Control is replaced,
the mode is automatically reset to [VCR1] Mode.
• The above operating ranges are for indoor use
Outdoors or under strong light, the Camcorder may
not operate properly even within the above ranges.
Selecting Remote Control Modes
When 2 Camcorders are used simultaneously, they
can be operated individually by selecting different
Remote Control Modes.
• If the Remote Control Mode of the Camcorder and
that of the Remote Control do not match, [CHECK
REMOTE MODE (REMOTE)] Indication is displayed.
Setup on the Camcorder:
Set [REMOTE] on the [INITIAL] Sub-Menu to the
desired Remote Control Mode. (p. 21)
Setup on the Remote Control:
15°
15°
15°
15°
1
2
31
Power Supply
Using the AC Adaptor
1 Connect the DC Cable to the Camcorder.
2 Connect the DC Cable to the AC Adaptor.
3 Connect the AC Cable to the AC Adaptor and
the AC Jack.
• Before connecting or disconnecting the power
supply, set the [OFF/ON] Switch
44
on the
Camcorder to [OFF] and make sure that
[POWER] Lamp is not lit. (p. 18)
Using the Battery
Before use, fully charge the Battery.
• We recommend using a Panasonic Battery.
• We cannot guarantee the quality of this Camcorder
when batteries from other companies are used.
1 Attach the Battery to the AC Adaptor and
charge it.
