10
For assistance, please call : 1-800-211-PANA(7262) or send e-mail : consumerproducts@panasonic.com
Initial Setup (Ready to Play)
For ANT./Cable
Connect the cable from
Antenna/Cable to the VHF/
UHF terminal on the unit.
For DSS/Cable Box
Connect the OUT jack on
your cable box to the VHF/
UHF terminal on the unit
with a RF cable.
UNIT
IN from
ANT./CABLE
VHF/UHF
WARNING:
Overtightening "Nut type" RF
coaxial cables may damage jacks.
Finger tighten only.
Cable TV
Converter Box
Connecting
Plug the unit power cord into
an AC wall outlet.
1
3
2
• If you use a cable box, turn it on and set it
to the Public Broadcasting Service (PBS)
channel in your time zone. If you use a
DSS receiver, it must be turned off.
Initial Setup (Ready to Play)
Please make all cable or antenna connections before powering on.
Press POWER* on the remote or unit.
The unit comes on and auto channel
and clock set starts.
CH AUTO SET PROCEEDING
Settings are made automatically.
When setup is done, this screen
appears.
PROCEEDING
AUTO CLOCK SET
CANCEL : PRESS STOP KEY
If AUTO CLOCK SET IS
INCOMPLETE screen appears, set
the clock using MANUAL CLOCK
SET procedure on next page.
PLEASE SET CLOCK BY
PRESS I NG ACT I ON KEY
AUTO CLOCK SET
I S I NCOMPLETE
2 / 6 / 2002 WED 12 : 00PM
DST : ON
AUTO CLOCK SET
COMPLETED
SETT I NG : CH 1 0
VHF/UHF
PV-27D52 Rear shown.
IN from
ANT./CABLE
VHF/UHF
VHF/UHF
20_25_27D52 (P10-11 Initial Setup).p65
2002/04/16, 13:30
10