19
Basic Operation
R-AUDIO OUT-L VIDEO OUT S-VIDEO OUT
L-AUDIO IN2-R
VIDEO IN2
S-VIDEO IN2
R-AUDIO IN1-L VIDEO IN1 S-VIDEO IN1
Playback (Source)
1
Recording (Editing) unit
Insert pre-recorded
tape.
Insert blank tape with
record tab.
• Dubbing tapes protected with
Copy Guard will have poor
quality results.
2
3
4
5
Press PLAY then press PAUSE at starting
point to put in Standby mode.
Press PLAY to start dubbing.
Press STOP to stop dubbing.
Select “LINE” mode.
See “Selecting Input Mode” below.
Selecting Input Mode
• Unauthorized exchanging and/or copying
of copyrighted recordings may be copyright
infringement.
• Please note that some tapes cannot be dubbed
on this unit. Also, it is not possible to dub
DVD/Video CD/CD to VHS tape using this unit.
Caution
(Perform operation of steps 4 and 5 on both units at same time.)
Copy Your Tapes (Dubbing)
Press REC, then press STILL/PAUSE
immediately to put in Standby mode.
Press STILL/PAUSE to start dubbing.
Press STOP to stop dubbing.
Method 1:
Press CH
. The display will change as follows.
Method 2:
a Press ACTION for MAIN MENU.
b Press
to select “TV,” then press SET
for SET UP TV screen.
c Press
to select “INPUT SELECT,” and
then press SET to select “TUNER,” “LINE1” or
“LINE2.”
d Press ACTION twice to exit this mode.
Connections you’ll need to make
Recording (Editing) unit
Playing (Source) VCR
*Important: If
a
remote control button does not work when pressed, press the
button on the remote and try
the button again.
If cables are connected to both connectors (S-VIDEO IN or VIDEO IN), the S-VIDEO
signal will be selected automatically. (The S-VIDEO signal has priority.) If you would
like to display the VIDEO signals being input to the VIDEO IN connector, do not
connect any cables to the S-VIDEO IN connector.
1
2
3
125
LINE1
(CABLE)
69
(TV)
or
LINE2
Summary of Contents for PVDF2703 - TV/VCR/DVD COMBO
Page 79: ...79 NOTES ...
