6.2.4. Grounding Plate Unit, Full Erase
Head, and Cylinder Unit
Fig. J2-1
6.2.4.1. Reassembly Notes
1. Adjustment of Grounding Plate Unit
a. After installing, make sure that the Grounding Plate Unit,
on the top side of mechanism chassis, is positioned on
the front side of the Cylinder shaft so that the center line
of the plate is just less than 1.0 mm measured from the
center of the Cylinder shaft.
If required, adjust the plate position by loosening Screw
(S-1).
Never install the Grounding Plate Unit on the rear side
of the Cylinder shaft.
Incorrect positioning will cause cylinder buzz.
Fig. J2-2
30
PVQ-1310 / PV-C1320 / PV-C1330W / VV-1300 / VV-1310W / PV-C1340 / PV-C1350W / PV-C2010 / PV-C2020 / PV-C2030W / VV-2000 / PV-C2060