6.3.1.1. Reassembly Notes
1. Alignment of Wiper Arm Unit and Drive Rack Unit
a. Slide the Drive Rack Unit to the far right as indicated by
the arrow.
b. Install the Wiper Arm Unit so that the hole on the Wiper
Arm Unit is aligned with the hole on the Drive Rack Unit.
Fig. K1-2
2. Installation of Holder Unit
a. Turn the Wiper Arm Unit so that the grooves on each
end are aligned with the each groove on Side Plate L
and R.
b. Insert Holder Unit boss (A) and (B) into the grooves as
shown in Fig. K1-1.
c.
Finally, in the EJECT Position, confirm that the
protrudence on the Wiper Arm Unit is aligned with the
indentation on the Drive Rack Unit.
Fig. K1-3
3. Make sure to hook the spring to the Drive Rack Arm of
Mechanism chassis.
6.3.2. Opener Lever and Drive Rack Unit
Fig. K2
39
PVQ-1310 / PV-C1320 / PV-C1330W / VV-1300 / VV-1310W / PV-C1340 / PV-C1350W / PV-C2010 / PV-C2020 / PV-C2030W / VV-2000 / PV-C2060
