Fig. E9-2
6. Select SUB BRIGHT in EVR adjustment mode and reset to
the original value.
7.3.12. PURITY ADJUSTMENT
Purpose:
To set the uniform white over the whole
screen.
Symptom of
Misadjustment:
The white screen will vary from area to
area.
Test Point:
----------
Adjustment:
Pair of 4-Pole Convergence Magnet
Rings,
Pair of 6-Pole Convergence Magnet
Rings,
Pair of Purity Magnet Rings,
Deflection Yoke (CRT Unit),
G CUT -OFF (EVR)
Specification:
Refer to descriptions below.
Input:
Video Input Jack, Crosshatch Pattern
Signal,
White Pattern Signal
Mode:
STOP
Equipment:
Degaussing Coil,
NTSC Video Pattern Generator,
White Pattern Generator
1. Remove the wedges from the CRT.
2. Slide the Deflection Yoke forward to the end of the CRT
neck.
(Model: A, B, C, D, E, F, G)
Set the Convergence Yoke as specified.
3. Power the unit "ON" and degauss the CRT by the
Degaussing Coil.
4. Supply the Crosshatch Pattern Signal to Video Input Jack.
5. Turn the pair of 4-Pole Convergence Magnet Rings so that
B and R at the center of CRT overlap each other.
6. Turn the pair of 6-Pole Convergence Magnet Rings so that
B and R which overlapped each other in Step 5 overlap G.
7. Supply a White Pattern Signal to Video Input Jack.
8. Select G CUT -OFF in EVR adjustment mode and adjust it
to become to the minimum level. Turn the Pair of Purity
Magnet Rings so that the distorted color areas are
approximately across from each other.
Slide the Deflection Yoke back slightly (without rotating it)
until the distorted color areas disappear from the screen.
9. Supply a Crosshatch Pattern Signal to Video Input Jack
again. Confirm that the Center Bar is at the horizontal
center line of the CRT and the V-Center Bar is at the
vertical center line of the CRT. Then, tighten the Expansion
Screw.
10. Press DISPLAY key (Service Switch) on the remote control
for collapse scan. (Refer to How to Enter Service Mode.)
Select G CUT -OFF in EVR adjustment mode and Adjust so
that the horizontal line is white.
11. Press DISPLAY key on the remote control again to return
for full frame scan. Make sure that the entire screen is
white. If not, adjust G DRIVE and B DRIVE in EVR
adjustment mode.
53
PVQ-1310 / PV-C1320 / PV-C1330W / VV-1300 / VV-1310W / PV-C1340 / PV-C1350W / PV-C2010 / PV-C2020 / PV-C2030W / VV-2000 / PV-C2060
