RQT8993
10
11
RQT8993
Precautions
The unit
This unit uses the 2.4 GHz radio frequency
band (
Bluetooth
). However other wireless
equipment may use the same frequency. Be
sure to take note of the following to prevent
radio wave interference from other equipment.
Restriction of use
For use only in your country.
Range of use
The range of use is up to approximately 10 m
(33 ft.). The range may be less depending on
the structure of the building, the environment
and any obstacles between the receiver and
the transmitter. Such obstacles as reinforced
concrete walls and metal doors, in particular,
obstruct the transmitter’s signals.
Interference from other equipment
Due to radio interference, malfunctions such as
sound distortion may occur if the unit is placed
too close to other equipment. We recommend
keeping the unit as far away as possible from
the following devices:
■
■
■
Bluetooth
devices other than this unit, wireless
LAN, microwaves, office automation devices,
digital cordless telephones and other electronic
devices
The unit is designed to automatically avoid
radio interference from these household
devices. However the sound will be broken
when radio interference occurs.
Using the unit
●
Do not drop, hit or otherwise subject the
transmitter or receiver to strong shocks of
any kind. This may cause damage.
●
Do not expose the unit to water or other
liquids as it may cause damage.
●
Do not use near microwave ovens,
pacemakers or other industrial, chemical or
medical equipment.
●
Do not use inside an aircraft, as this may
compromise the safety of the aircraft.
●
Keep the ear pads, out of the reach of children
to prevent them from being swallowed.
■
Basic flow of operations
Connect the transmitter to the iPod
®
.
Connect it to the iPod
®
’s dock connector.
(Refer to page 15.)
• Prior to shipment from the
m a n u f a c t u r i n g p l a n t , t h e
transmitter and receiver pair is
registered.
Setting the pair
Use a
Bluetooth
connection for the receiver and
transmitter that has been connected to the iPod
®
.
The pair setting is performed
automatically.
(Refer to page 15.)
Listening to music
• You can listen to the music played by the iPod
®
with
the receiver.
• You can play, pause and control the music in other
ways with the receiver.
(Refer to page 16.)
Registering the device pair
The receiver and
Bluetooth
cellphone must be registered
for the parties to be connected. Once they have been
registered, they need not be registered again.
(Refer to page 18.)
Setting the pair
Use a
Bluetooth
connection for the receiver and
Bluetooth
cellphone.
(Refer to page 19.)
Talking on the phone
You can now operate the receiver and receive incoming
calls.
(Refer to page 20.)
Listening to music
Talking on the phone
Summary of Contents for RP-BT10-W
Page 30: ...RQT8993 30 Memo ...
Page 31: ...31 RQT8993 Memo ...
