Panasonic RP-BT10-W, Operating Instructions Manual

RQT8993

14

15

RQT8993

Preparations (prior to use)

Concerning the connection of the stereo earphones (L, R)

Insert the input plug of the stereo earphones into the AUDIO OUT connector for use.

How to fit the stereo earphones into your ears properly

If the earpieces are not fitted snugly into your ears, you may not obtain a good seal or hear bass sounds. Fit them 
into your ears snugly for a better sound quality listening experience.

■

  Lift the upper part of your left ear lobe 

using your right hand (and vice versa).

  Twist slightly and gently push the 

earphones in.

Concerning the ear pads

Your earphones are fitted with M size ear pads at the time of their purchase.
If you feel that they are too small or too large for your ears, replace them with the S or L size pads.

■

Listening to music on your iPod

®

Setting the pair

As soon as the receiver and transmitter power are turned on, the pair setting is performed automatically.

  Connect the transmitter to the dock 

connector on the bottom of the iPod

®

.

• The iPod

®

’s power is now automatically turned on.

  Press and hold the MIC button on the 

receiver for 2 seconds.

•  The receiver’s power is now turned on, and the lamp 

(red) blinks slowly.

  Press and hold the Transmitter button on 

the transmitter for 2 seconds.

•  The transmitter’s lamp (red) starts blinking rapidly, and 

when the pair setting is completed, the lamps (blue) 
on the transmitter and receiver start blinking slowly to 
indicate that the pair setting has been completed.

Note: 

•  To establish pairing again after pairing has been 

released or the transmitter’s power was turned 
off, press and hold the Transmitter button on 
the transmitter for 2 seconds. The pair setting is 
restored.

Notes: 

•  Discontinue use if you experience discomfort. Continued use may cause rashes or other allergic reactions.
•  You could damage your ears if the volume is raised too high. Avoid listening for prolonged periods of time to 

prevent hearing damage. (Refer to page 28.)