Panasonic RP-BT10-W, Operating Instructions Manual

RQT8993

18

19

RQT8993

Talking on your cellphone

Registering the device pair

In order to establish the wireless connection between the receiver and 

Bluetooth

 cellphone, the receiver and 

cellphone pair must be registered.

•  

Operations involving the receiver

 Press and hold the MIC button on the receiver for 2 seconds.

  The receiver’s power is turned on, and its lamp (red) starts blinking slowly.

 Press and hold the [–] button on the receiver for 6 seconds.

  The lamp (red) starts blinking rapidly.

Caution:   

While the lamp (red) blinks rapidly (for about 60 seconds), register the pairing of the 
receiver and 

Bluetooth

 cellphone. Repeat step 

 if the lamp (red) starts blinking 

slowly.

•  

Operations involving the Bluetooth cellphone

 Using your cellphone, conduct a Bluetooth device search.

Caution: 

•  A list of detected devices is displayed on the cellphone screen, and “RP-BT10R 

Panasonic” is displayed for the receiver. 
If “RP-BT10R Panasonic” is not displayed, repeat the procedure from step 

.

 • 

If you are requested to input the pass key, input “0000.”

Notes: 

•  For further details on conducting the 

Bluetooth

 device search, refer to the operating 

instructions of your cellphone.

 • 

Once the pairing has been registered, it need not be registered again. 

 • 

 It may not be possible to register the pairing with some cellphones because they use 
a different data transfer format.

Setting the pair

In order to establish the wireless connection between the receiver and 

Bluetooth

 cellphone, the receiver and 

cellphone pair must first be registered.

Before operating the units, check the following points.

•  Has the pairing of the receiver and cellphone you are about to use been registered? (Refer to page 18.)

 Press and hold the MIC button on the receiver for 2 seconds.

The receiver’s power is turned on, and its lamp (red) starts blinking slowly.

  Establish a “hands-free” connection by performing the Bluetooth 

connection operation on your cellphone.

•  When the pair setting is completed, the receiver’s lamp (blue) starts blinking 

slowly.

•  To establish pairing again after pairing has been released or the receiver’s 

power was turned off, press the MIC button on the receiver once, then check the 
connection with the cellphone.

Note:

•   For further details on the 

Bluetooth

 connection operation, refer to the operating instructions of your cellphone.

Hands

-free