Panasonic RP-BT10-W, Operating Instructions Manual

RQT8993

20

21

RQT8993

Talking on your cellphone

Talking on the phone

Receiving incoming calls

 You will hear the incoming call tone when someone calls 
the number of your cellphone.

-

  To talk to the other party, 

Press the MIC button on the 

receiver.

-

  To switch the call to your cellphone, 

Press and hold the 

MIC button on the receiver for 2 seconds after the 
call has been connected.

-

  To refuse the call, 

Press and hold the MIC button on the receiver for 2 seconds during the call tone.

Hanging up

 Press the MIC button on the receiver. 

The call is now terminated.

Notes: 

•   If you receive a call while music is playing on the iPod

®

, the iPod

®

 music will be temporarily suspended, 

and you will hear the incoming call tone.

 • 

When the call is terminated, the iPod

®

 music will resume.

Adjusting the call volume

The call volume can be adjusted by pressing the [+] and [–] buttons.

Notes: 

•  The call volume cannot be adjusted during call standby.

 • 

You can select separate settings for the call volume level and music play level.

Winding up an operation session

 Disconnect the Bluetooth connection using your cellphone.

Note: 

•  For further details on disconnecting the 

Bluetooth

 connection, refer to the operating 

instructions of your cellphone.

 Press and hold the MIC button on the receiver for 6 seconds.

The receiver’s power is turned off, and its lamp (red) goes off.

■

■

Listening to music on your cellphone

Setting the pair

In order to establish the wireless connection between the receiver and 

Bluetooth

 cellphone, the receiver and 

cellphone pair must first be registered.

Before operating the units, check the following points.

•   Has the pairing of the receiver and cellphone you are about to use been registered? (Refer to page 18.)

   Press and hold the MIC button on the receiver for 2 seconds.

The receiver’s power is turned on, and its lamp (red) starts blinking slowly.

   Establish the “audio” connection by performing the Bluetooth 

connection operation on your cellphone.

   Perform the audio playback operation using the above cellphone.

 When the pair setting is completed, the receiver’s lamp (blue) starts blinking slowly.

 • 

Perform the operation for transmitting to the 

Bluetooth

 device.

 • 

The receiver starts receiving, and the playback sound can be heard through 
the earphones.

Note: 

•  For further details on the 

Bluetooth

 connection, refer to the operating 

instructions of your cellphone.

MIC

Audio