Panasonic RP-BT10-W, Operating Instructions Manual

RQT8993

4

5

RQT8993

The socket outlet shall be installed near 
the equipment and easily accessible. The 
mains plug of the power supply cord shall 
remain readily operable. To completely 
disconnect this apparatus from the AC 
Mains, disconnect the power supply cord 
plug from AC receptacle.

CAUTION

Danger of explosion if battery is  incorrectly 
replaced. Replace only with the same or 
equivalent type recommended by the 
manufacturer.
Dispose of used batteries according to the 
manufacturer’s instructions.

A nickel metal hydride battery 
that is recyclable powers the 
product you have purchased.
P l e a s e   c a l l   1 - 8 0 0 - 8 -
BATTERY for information on 
how to recycle this battery.

The receiver (handsfree unit) is certified under 
FCC ID: ACJRPBT10R. The FCC ID is also 
located on the battery cover and inside the battery 
compartment.

-If you see this symbol-

Information on Disposal in other 

Countries outside the European Union

This symbol is only valid in the 

European Union. 

If you wish to discard this 

product, please contact your 

local authorities or dealer and 

ask for the correct method of 

disposal.

FCC Note:

This equipment has been tested and found to comply with the limits for a Class B digital device, 
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection 
against harmful interference in a residential installation. This equipment generates, uses and can radiate 
radio frequency energy and, if not installed and used in accordance with the instructions, may cause 
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does 
cause harmful interference to radio or television reception, which can be determined by turning the equipment 
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•  Reorient or relocate the receiving antenna.
•  Increase the separation between the equipment and receiver.
•   Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•  Consult the dealer or an experienced radio/TV technician for help.
FCC caution: To maintain compliance with FCC regulations, shielded interface cables must be used 
with this equipment. Operation with non-approved equipment or unshielded cables may result in 
interference to radio and TV reception. Any changes or modifications not approved by the party 
responsible for compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 
(1) This device may not cause harmful interference, and 
(2)  this device must accept any interference received, including interference that may cause undesired 

operation.

Declaration of Conformity
Trade Name:  Panasonic
Model No.: 

RP-BT10

Responsible Party:  

Panasonic Corporation of North America 

One Panasonic Way 

Secaucus, NJ 07094

Support Contact:    

Panasonic Consumer Electronics Company

Telephone 

No.: 

1-800-211-7262