29
9 Disassembly and Assembly Instructions
Caution Note:
• This section describes the disassembly and/or assembly procedures for all major printed circuit boards & main compo-
nents for the unit. (You may refer to the section of “Main components and P.C.B Locations” as described in the service
manual)
• Before carrying out the disassembly process, please ensure all the safety precautions & procedures are followed.
• During the disassembly and/or assembly process, please handle with care as there may be chassis components with
sharp edges.
• Avoid touching heatsinks due to its high temperature after prolong use. (See caution as described below)
• During disassembly and assembly, please ensure proper service tools, equipments or jigs is being used.
• During replacement of component parts, please refer to the section of “Replacement Parts List” as described in the
service manual.
• Select items from the following indexes when disassembly or replacement are required.
• Disassembly of Top Cabinet
• Disassembly of Tuner P.C.B.
• Disassembly of Front Panel Assembly
• Disassembly of Panel P.C.B.
• Disassembly of Remote Sensor P.C.B.
• Disassembly of CD Open Button P.C.B.
• Disassembly of USB P.C.B.
• Disassembly of CD Lid
• Disassembly of Main P.C.B.
• Disassembly of Regulator IC (IC2701)
• Disassembly of D-Amp P.C.B.
• Disassembly of Audio Digital Amp IC (IC5900)
• Disassembly of SMPS P.C.B.
• Disassembly of Switching Regulator IC (IC5701)
• Disassembly of Regulator Diode (D5702)
• Disassembly of Regulator Diode (D5801)
• Disassembly of Regulator Diode (D5802)
• Disassembly of Regulator Diode (D5803)
• Disassembly of CD Mechanism Unit (DLS6C)
• Disassembly of CD Servo P.C.B.
• Disassembly of Rear Panel
• Disassembly of Voltage Selector P.C.B. (For PH only)
Summary of Contents for SA-AKX10PH
