25
8.5.2.
CD Mechanism Error Code Table (CD Mechanism Unit)
8.6.
Sales Demonstration Lock Function
8.6.1.
Entering into Sales demonstration lock mode
Here is the procedures to enter into the Sales demonstration lock mode.
Step 1: Turn on the unit.
Step 2: Select to any mode function.
Step 3: Press and hold [
OPEN/CLOSE
] and [CD] keys for 5 sec or more.
The display will show upon entering into this mode for 2 sec..
Note: [
OPEN/CLOSE
] button is invalid and the main unit displays “LOCKED” while the lock function mode is entered.
8.6.2.
Cancellation of Sales demonstration lock mode
Step 1: Turn on the unit.
Step 2: Select to any mode function.
Step 3: Set volume to Vol 19.
Step 4: Press and hold [
OPEN/CLOSE
] and [CD] keys for 5 sec or more.
The display will show upon entering into this mode for 2 sec..
Error Code
Diagnostic Contents
Description of error
Automatic FL Display
Remarks
CD H15
CD Open Abnormal
During operation
POS_SW_R On fail to be
detected with 4 sec. Error
No. shall be clear by force
or during cold start.
Press [ ] on main unit for
next error.
CD H16
CD Closing Abnormal
During operation
POS_SW_CEN On fail to
be detected with 4 sec.
Error No. shall be clear by
force or during cold start.
Press [ ] on main unit for
next error.
F26
Communication between
CD servo LSI and micro-p
abnormal.
During switch to CD func-
tion, if SENSE = “L” within
failsafe time of 20ms.
Press [ ] on main unit for
next error.
Summary of Contents for SA-AKX36PH
