42
Step 5 Detach 2P Wire at the connector (CN2005) on the Main
P.C.B..
Step 6 Detach 30P FFC at the connector (CN2009) on the
Main P.C.B..
Step 7 Remove the Main P.C.B..
Caution: During assembling, ensure that earth plate is
bended flat against the Main P.C.B. properly before insert-
ing into the slots of the Bottom Chassis.
11.13. Replacement of Voltage Regu-
lator IC (IC2010)
• Refer to “Disassembly of Main P.C.B.”.
11.13.1. Disassembly of Voltage Regulator
IC
(IC2010)
Step 1 Desolder pins of the Voltage Regulator IC (IC2010) on
the solder side of the Main P.C.B..
Step 2 Remove the Voltage Regulator IC (IC2010) from the
Main P.C.B..
Summary of Contents for SA-AKX54PH
