45
9.13.2.
Assembly of Voltage Regulator IC
(IC2010)
Step 1 Apply grease to the Heatsink.
Step 2 Fix the Voltage Regulator IC (IC2010) on Main P.C.B..
Caution: Ensure pins of the Voltage Regulator IC (IC2010)
are properly seated on Main P.C.B..
Step 3 Screw the Voltage Regulator IC (IC2010) to the Heat-
sink.
Caution: Ensure the Voltage Regulator IC (IC2010) is tightly
screwed to the Heatsink.
Step 4 Solder pins of the Voltage Regulator IC (IC2010) on the
solder side of Main P.C.B..
9.14. Disassembly of D-Amp P.C.B.
• Refer to “Disassembly of Top Cabinet”.
• Refer to “Disassembly of Front Panel Unit”.
Step 1 Remove 2 screws.
Step 2 Twist the Wire Holder to release 6P Cable Wire.
Step 3 Detach 6P Cable Wire at the connector (CN5801) on
SMPS P.C.B.
Summary of Contents for SA-AKX92PH
