48
9.15.1.
Assembly of Audio Digital Amp IC
(IC5000)
Step 1 Fix the Audio Digital Amp IC (IC5000) on to D-Amp
P.C.B..
Step 2 Screw back TR Spring to hold the Audio Digital Amp IC
(IC5000) onto the Heatsink Power Unit.
Step 3 Solder the pins of Audio Digital Amp IC.
Step 4 Use a blower to remove the minute particles after the
screwing of TR Spring.
Caution: Ensure pins of the Audio Digital Amp IC (IC5000)
are properly seated and soldered on D-Amp P.C.B..
9.16. Replacement of Audio Digital
Amp IC (IC5400)
• Refer to “Disassembly of D-Amp P.C.B.”.
Step 1 Flip over D-Amp P.C.B..
Step 2 Desolder pins of the Audio Digital Amp IC (IC5400) on
the solder side of D-Amp P.C.B..
Step 3 Remove 1 screw.
Step 4 Remove TR Spring in the direction of arrow shown.
Step 5 Remove Audio Digital Amp IC (IC5400) from the heat
sink unit.
Caution: During replacement of the part, avoid touching
the heatsink, it may lead to injuries.
Summary of Contents for SA-AKX92PH
