35
RQT8221
Progressive video
Page
Listening to the radio
Television operation
Digital receiver
Unit displays
Television displays
There is ghosting when
progressive output is on.
≥
This problem is caused by the editing method or material used on DVD-Video, but should be
corrected if you use interlace output. Change “Video Output Mode” in Picture Menu to “625i (or 576i)”
or “525i (or 480i)”.
19
Pictures not in progressive
output.
≥
Press [PROGRESSIVE] on the main unit so “PRG” is displayed. Or select “625p (or 576p)” or
“525p (or 480p)” in “Video Output Mode” in Picture Menu.
≥
If the unit is connected to the television through VIDEO OUT, S-VIDEO OUT or SCART (AV)
terminal, output will be interlace even if “PRG” is displayed.
12,
19
7
Noise is heard.
“ST” flickers or doesn’t light.
Sound is distorted.
≥
Adjust the position of the FM or AM antenna.
≥
Use an outdoor antenna.
—
23
A beat sound is heard.
≥
Turn the television off or move it away from the unit.
—
A low hum is heard during AM
broadcasts.
≥
Separate the antenna from other cables.
—
Cannot operate the TV.
≥
Press [TV] first to operate the television.
≥
Check the remote control code for the TV manufacturer.
—
27
Wireless link indicator does not
light.
≥
Check that the main unit and the digital receiver are turned on.
≥
Ensure that the digital transmitter is fully inserted into the slot of the main unit.
9
8
The display is dark.
≥
Select “Bright” in “FL Dimmer” in the “Others” tab.
21
“NO PLAY”
≥
You inserted a disc the unit cannot play; insert one it can.
≥
You inserted a blank disc.
11
—
“NO DISC”
≥
You haven’t inserted a disc; insert one.
≥
You haven’t inserted the disc correctly; insert it correctly.
—
12
“F61”
≥
Check and correct the speaker cord connections.
If this does not fix the problem, there is a power supply problem. Consult the dealer.
4, 6
“DVD U11”
≥
Disc may be dirty. Wipe it clean.
30
“ERROR”
≥
Incorrect operation performed. Read the instructions and try again.
—
“DVD H
∑∑
”
∑∑
stands for a number.
≥
Trouble may have occurred. The number following “H” depends on the status of the unit. Turn the
unit off and then back to ON. Alternatively, turn the unit off, disconnect the AC mains lead, and
then reconnect it.
≥
If the service numbers fail to clear, note the service number and contact a qualified service
person.
—
—
“
[W]
” is flashing.
≥
There is no link between the main unit and the digital receiver. Check that the digital receiver is
turned on.
9
“W01” is flashing or lit.
≥
Re-initialize the main unit: While stopped and “DVD/CD” is the source, press and hold [
∫
] on the
main unit and [
S
10] on the remote control until “Initialised” (or “Initialized”) disappears from the
television. Turn the unit off and on again. If the problem persists, contact a qualified service
person.
—
“
/
”
≥
The operation is prohibited by the unit or disc.
—
“Cannot play group xx, content
xx”
“Cannot display group xx,
content xx”
≥
You are trying to play incompatible group or content.
—
“Group xx, content xx is
protected”
≥
You are trying to play protected group or content. You cannot play it.
—
“Cannot play audio”
“No audio”
≥
Audio has not been recorded, or recorded in a format this unit cannot playback. Video playback
only is possible.
17
“Check the disc”
≥
This disc may be dirty.
30
“This disc may not be played in
your region”
≥
You can only play DVD-Video if their region number is the same or includes the same region
number as the unit or if the DVD-Video is marked “ALL”. Confirm the region number for the unit
on the rear panel.
Cover
page
No on-screen display.
≥
Select “On” in “On-Screen Messages” in the “Display” tab.
21
“Authorization Error”
[DivX]
≥
You are trying to play the DivX VOD content that was purchased with a different registration
code. You cannot play the content on this unit.
30
“Rented Movie Expired”
[DivX]
≥
The DivX VOD content has zero remaining plays. You cannot play it.
30
T
roub
le
s
hoo
ting guide
HT885W_En.book Page 35 Thursday, October 20, 2005 12:31 PM
