RQ
T
8
8
0
4
37
T
roub
le
sh
oo
tin
g
g
u
id
e
Progressive video
Page
Listening to the radio
Unit displays
Television displays
There is ghosting when
progressive or HDMI output is on.
≥
This problem is caused by the editing method or material used on DVD-Video, but should be
corrected if you use interlaced output. Set “Video Output Mode” in Picture Menu to “480i” or “576i”.
(Alternatively, press and hold [CANCEL] to switch to “480i” or “576i”.)
≥
Disable the HDMI AV OUT connection and use other video connections. Make the settings in the
following order:
1 Set “Video Output” in the “HDMI” tab to “Off”.
2 Set “Video Output Mode” in Picture Menu to “480i” or “576i”. (Alternatively, press and hold
[CANCEL] to switch to “480i” or “576i”.)
23
23,
27
Pictures not in progressive
output.
≥
Select “480p” or “576p” in “Video Output Mode” in Picture Menu.
≥
The unit’s VIDEO OUT or S-VIDEO OUT terminal outputs the interlaced signal even if “PRG” is
displayed.
23
10, 11
Distorted sound or noise is heard.
“ST” flickers or does not light.
≥
Adjust the position of the FM or AM antenna.
≥
Use an outdoor antenna.
—
30
A beat sound is heard.
≥
Turn the television off or move it away from the unit.
—
A low hum is heard during AM
broadcasts.
≥
Separate the antenna from other cables.
—
The display is dark.
≥
Select “Bright” in “FL Dimmer” in the “Others” tab.
28
“NO PLAY”
≥
You inserted a disc the unit cannot play; insert one it can.
≥
You inserted a blank disc.
≥
You inserted a disc that has not been finalized.
15
—
—
“NO DISC”
≥
You have not inserted a disc; insert one.
≥
You have not inserted the disc correctly; insert it correctly.
—
16
“F61”
≥
Check and correct the speaker cable connections.
If this does not fix the problem, consult the dealer.
6, 9
“DVD U11”
≥
Disc may be dirty. Wipe it clean.
15
“ERROR”
≥
Incorrect operation performed. Read the instructions and try again.
—
“DVD H
∑∑
”
“DVD F
∑∑∑
”
∑
stands for a number.
≥
Trouble may have occurred. The numbers following “H” and “F” depend on the status of the unit.
Turn the unit off and then back on. Alternatively, turn the unit off, disconnect the AC mains lead, and
then reconnect it.
≥
If the service numbers fail to clear, note the service number and contact a qualified service person.
—
—
“D.MIX” is flashing.
[DVD-A]
≥
Down-mixing is the process of remixing the multiple-channel audio found on some discs into two
channels. The disc contains single-channel or multiple-channel signals which may not be
reproduced authentically.
—
“U701”
≥
The connected equipment is not HDMI-compatible.
—
“U70
∑
”
∑
stands for a number.
The actual number following “U70” will
depend on the state of the main unit.
≥
The HDMI connection acts unusually.
– The connected equipment is not HDMI-compatible.
– The HDMI cable is too long.
– The HDMI cable is damaged.
—
—
—
“
/
”
≥
The operation is prohibited by the unit or disc.
—
“Cannot play group xx, content xx”
“Cannot display group xx, content xx”
≥
You are trying to display incompatible group or content.
—
“This disc may not be played in
your region”
≥
Only DVD-Video discs that include or have the same region number as the one on the rear panel of
this unit can be played.
Cover
page
No on-screen display.
≥
Select “On” in “On-Screen Messages” in the “Display” tab.
28
“Group xx content xx is
protected”
≥
You are trying to play protected group or content. You cannot play it.
—
“Check the disc”
≥
This disc may be dirty.
15
“Authorization Error”
[DivX]
≥
You are trying to play the DivX VOD content that was purchased with a different registration code.
You cannot play the content on this unit.
5
[Southeast]Asia]
“Rental Expired”
[DivX]
[Others]
“Rented Movie Expired”
[DivX]
≥
The DivX VOD content has zero remaining plays. You cannot play it.
5
“Due to copyright protection,
audio cannot be output from
HDMI”
[DVD-A]
≥
If you connect to equipment that does not support CPPM (
➜
page 38, Glossary), audio from a
CPPM copy-protected DVD-Audio disc cannot be output from the HDMI AV OUT terminal.
—
Main unit’s screen saver remains.
≥
When using the HDMI connection, audio/video information is continually transferred between the main
unit and the television regardless of which source has been selected on the main unit. This is normal.
—
HT892 En.book Page 37 Friday, June 2, 2006 7:49 PM
