10 Service Position
Note: For description of the disassembly procedures, see
the Section 9.
10.1. Checking of FL Display P.C.B.,
Control P.C.B., Volume P.C.B.,
Mic P.C.B. and USB P.C.B.
Step 1 Remove Top Cabinet.
Step 2 Remove Front Panel Unit.
Step 3 Remove FL Display P.C.B..
Step 4 Remove Illumination Button P.C.B..
Step 5 Remove Control P.C.B..
Step 6 Remove Volume P.C.B..
Step 7 Remove USB P.C.B..
Step 8 Remove Mic P.C.B..
Step 9 Attach 10P FFC at the connector (CN2002) on Main
P.C.B..
Step 10 Attach 11P Cable at the connector (CN2001) on Main
P.C.B..
Step 11 Attach 30P FFC at the connector (CN2004) on Main
P.C.B..
Step 12 Attach 2P Cable at the connector (CN6800) on Illumi-
nation Button P.C.B..
Step 13 Attach 8P Cable at the connector (CN6103) on Mic
P.C.B..
Step 14 Attach 12P Cable at the connector (CN6200) on Con-
trol P.C.B..
Step 15 Attach 30P FFC at the connector (CN6002) on FL Dis-
play P.C.B..
Step 16 Attach 5P Wire at the connector (FP3001) on Main
P.C.B..
Step 17 FL Display P.C.B., Control P.C.B., Volume P.C.B., Mic
P.C.B. and USB P.C.B. can be checked as diagram shown.
Summary of Contents for SA-MAX750LMK
